Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need to
be adjusted. You can adjust them
manually by hand or by using a suitable
spanner.
To allow the doors to self-close, tilt the
top backwards by 10-15mm.
Note:
If required you may lay the refrigerator
on its back in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the
refrigerator.
There is no need to install these
accessories under normal usage.
Only under the extreme circumstances,
that is opening the door about 90
degree, this refrigerator may take risk of
tipping. Then rubber supporting pad
should be fastened to the lower base
cover to steady this appliance.
1. Tilt appliance to find screw hole on
the left of lower base cover.
2. Put screw into the hole of rubber
supporting pad.
3. Make screw in alignment with the hole
on lower base cover. Fasten rubber
supporting pad to the base cover firmly
by a cross screwdriver (self-provided).
rubber supporting pad
screw
2
cross screwdriver
1
Adjustable bottom feet
10-15
mm
A
B
C
A
B
C
Adjustable bottom
feet
Front roller
Rear roller
lower base cover
12
