Note:
If required, you may lay the refrigerator
on its back in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the refrigerator.
To reverse the door, the following steps
generally recommended.
1. Stand the refrigerator upright. Open the
door to take out all door racks (to avoid
damage) and then close the door.
Caution!
Please slightly squeeze the door rack from
one side toward center, and then move it
upward when taking out the door racks.
press in wardly
2.
Remove screw
①
, then take down
cover
②
from the top right side. Be
careful of the electrical connector
③
below, because it’s still connected. Then
unconnect it and remove cover
②.
3.Press the door switch
④
,then remove it
upward. Install switch
④
into cover
⑤
(provided in the plastic bag)
. Put the
other cover
②
into the plastic bag.
4.Unscrew screws
①
by a 8mm socket
driver or a spanner, and remove hinge
②
.
Then put the conector
③
into the hole.
Please hold the door by hand when
installing.
③
③
④
④
⑤
Upper hinge
cover-left
④
Eletrical connector
Door switch
①
①
②
②
③
Self-tapping screw
Upper hinge cover
Special flange screw
Upper hinge
Electrical connector
①
②
③
①
②
③
5.Remove the upper door from the
middle hinge by carefully lifting the door
straight up. Then Place the upper door
on a smooth surface with its upper cover
upwards.
6.Install cover
①
(provide in the plastic
bag) on the top right side.Then remove
cover
②
from top left side of the
appliance, and put it into the plastic bag.
①
Screw hole
cover-right
②
Screw hole
cover-left
7.
Loose screw
③
and take down part
②
and part
①
, Install replacement door
stopper-left
④
and stop block-left
⑤
(provided in the plastic bag) to the left
side with screw
③
. Keep part
①
and
part
②
with the appliance for future
reference.
⑤
⑤
①
②
③
①
Door stopper
②
Stop block
③
Self-tapping screw
④
Door stopper-left
stop block-left
④
15
Summary of Contents for RT641N4WFE
Page 197: ......