6
HSK2411202016 | Dynamic Terminal Ku 8X8 V2 | Quick Start Installation Guide
5.
Connect the Satellite and the Terminal
To establish connectivity between the satellite and the terminal, do the following:
•
Place the terminal on level ground or tripod mount.
•
Place the terminal in a clear line of sight between the terminal and the satellite. Any buildings, trees,
people, or other objects in the path may interfere with connectivity.
•
Wait for the status LED to turn solid green.
6.
Install the Terminal:
WARNING: Improper installation can lead to the device falling causing serious personal injury or damage to
equipment. The selected mounting solution must meet the local standard requirements.
The installer is responsible to make sure the installation will meet usage guidelines.
WARNING: Radio frequency hazard
–
keep a distance of at least 25 cm during terminal operation.
Mobile/On the move Installation:
Terminal installation on a vehicle uses custom-made magnets or other mounting solutions, depending on the vehicle. For
the most suitable solution, please contact your provider.
WARNING: The metal surface must be clean and straight, and all magnets should be firmly attached to the
metal before driving. Before a drive, secure the power cable. Avoid driving fast on bumpy roads and in
dangerous curves.
Fixed or Tripod Installation
Use the mounting interfaces described below, using at least the six M6 VESA 100X100 screws.
•
¼ Thread
–
Standard Tripod Mount.
•
100*100 VESA mount M6 Threads.
