hisky HMX280, Instruction Manual

7

.

1 Mode choice of Transmitter:

1) Please choose Fixed Wing Mode to fly the quadcopter with X-6S and H-6 transmitters

10

11

7

.

Preparation for flight and Unlock the motors

7

.

2 Steps of Flight:

3)

Bind the model with the transmitter.

4) After the binding, the signal light will Bind the model with the transmitter and make 

Step 1

Step 2

Step 3

turn on the transmitter first

connect the battery of the model with 

succeeding the binding, the signal light 

7

.

3 Unlock the motors

Push the aileron stick left side down for 

7

.

4 Lock the motors

Push the aileron stick right side down for 

2) Pull the throttle stick of the transmitter to the lowest position and turn on the 
    transmitter. Connect the battery joint with that of the main board in the airframe 
    and close the battery cover.

1) Install the battery. Open the battery bay of the quad and place the battery into 
     the battery bay.

the main board.

on the airframe turn flash in green slowly.

2-3S and release then unlock the motors

2-3S and release then Lock the motors

7.5 Notice:

1) Please follow the order ”turn on the transmitter first and then connect the 
    battery of the model”.After turn on the transmitter, then connect the battery 
    of the quadcopter  with the main board in 10s.The light of signal will change 
    from flash to ever green in 1-3s.Then the binding succeeds.

2) Fail to connect the battery in 10s, please disconnect the battery ,turn off the 
    transmitter and repeat the step above.

Trouble shooting: a flashing receiver light after connecting the battery:

Possible causes

Solutions

Fail the binding 

Turn transmitter off and then on  and 
reconnect the battery, rebind

The throttle stick of transmitter is 
not at the lowest position 

Pull down the throttle stick to  the 
lowest position and rebinding.

The transmitter battery is low and 
empty

Replace transmitter battery and 
rebinding.

The HMX280 battery is low and 
empty 

Replace the HMX280 battery and 
rebind

No function of receiver and 
transmitter

Replace receiver or transmitter and 
rebind

sure the distance of them within 10cm.

Step 4

You can fly the quad after close the battery

 back  hatch.

Notice:

 Please follow the order ” turn on the transmitter first and then connect 

the battery of the model”.

(When lock the motors, the green signal 

light will flash more slowly.)