-
2
-
Assembly instructions
The telephone is a two-part unit, the main unit and the Speaker unit.
The main unit is to be mounted on the wall in the lift machine room.
The speaker unit is to be mounted on either the lift car wall or ceiling.
It is also possible to mount the main unit on the lift car roof, but it is than required to place the
telephone line in a separate carcable.
The alarm signal switch can be changed between NO (normally-open)/NC (normally-closed).
The delay time, when the alarm signal switch is pushed, is adjustable 2-15 seconds.
Transmission is done by a relay contact that can be changed between
normally-open/normally-closed.
An separate input is dedicated for battery alarm from an external battery alarm contact
The contact must be NO (normally open).
Mount the speaker unit in the lift car, either on the wall or the ceiling.
To connect the speaker unit, 4-parts in the lift car cable are needed.
The speaker unit can always be connected to existing lift car cable since it is galvanically separated
from the (PSTN) telephone network.
The telephone is using S.K. P100 and CPC protocol for communication with the operator that
receives the alarm.
S.K. P100 and CPC protocol is the most frequent alarm protocol in Scandinavia,
and it is also used in our own alarm reciever equipment.
Check that the alarm-receiving operator has a receiver fitted for P100/CPC protocol,
voice call, if you plan to use this protocol.
Mic/loudspeaker unit:
The unit has an automatic test that checks the function in the microphone/loudspeaker unit when
the unit is connected to power and is thereafter made every 24-hours.
It is now easy to check if the remote-part is correctly connected:
When power is connected the test is done, the LED-diod ”line” will after a few seconds indicate
with 5 green blinks if the remote unit is correctly connected or with 5 red blinks if connected
incorrectly.
The LED placed between the microphone and speaker indicates:
When blinking 1sec on 5sec off: mic/ loudspeaker is working.
If solid red light: a call is connected (line is busy).
Hisselektronik AB
Antenn
väge
n
10
135
48
T
YRESÖ
Tel. 08-4477932
Fax. 08-4477931