Operating the Engine
7-2
①
Range gear shift lever.
(L) Low Range
(H) High Range
(N) “Neutral” position
(R) “REVERSE”
3. Push the accelerator pedal down slowly.
①
Speed control pedal
②＝＞③
INCREASE
③＝＞②
DECREASE
1. Insert the key into the key switch and turn
it “START”.
OFF (Stop the Engine)
ON
(Engine runs or headlights on)
START (Start the Engine)
IMPORTANT :
It is not sufficient to do daily checks on
dash board only. Always conduct daily
checks carefully by referring to “DAILY
CHECK“ in “PERIODIC SERVICE”
section.
5. Turn the key to “START” position and
release when the engine starts.
IMPORTANT:
Because of safety devices, the engine
will not start except when the gear shift
lever is placed in the “NEUTRAL”
position and the brake is depressed.
■
Cold Starting
When the ambient temperature is below -
15
℃
( 5
℉
), the engine is very cold. If the
engine fails to start after 5 seconds, turn off
the key for 30 seconds and start again.
STOPPING THE ENGINE
1. After slowing the engine to idle, turn the
key to “OFF”.
2. Remove the key.
WARMING UP
CAUTION
：
To avoid personal injury:
Be sure to set the parking brake
during warm-up.
Be sure to set the shift lever to the
Summary of Contents for 550UTV/HS
