Periodic Service
10-15
is worn to minimum allowable.
①
3mm(0.12in)
EVERY 400 HOURS
■
Changing Transmission Fluid
CAUTION
To avoid personal injury:
Park the vehicle on a flat surface,
raise the cargo bed, mount the safety
support.
Allow engine to cool down
sufficiently, oil can be hot and can
burn.
1. Park the vehicle on a flat surface, raise
the cargo bed, mount the safety
support.
2. To drain the used oil, remove the drain
plug at the bottom of the transmission
case and drain the oil completely into
the oil pan.
3. After draining, reinstall the drain plug.
4. After running the engine for a few
minutes, stop the engine and check the
oil level again; add oil to prescribed
level.
①
Drain plug
IMPORTANT:
Do not operate the vehicle immediately after
changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent damage to the
transmission.
■
Changing Front and Rear Axle Case Oil
1. Park the vehicle on a firm, flat and level
surface.
2. To drain the used oil, remove the drain the
oil completely into the oil pan.
3. Fill with the new oil up to the upper notch on
the dipstick.
(See “LUBRICANTS, FUEL AND COOLANT”
in “MAINTENANCE” section.)
4. After filling, reinstall the filling plug.
Oil capacity for
front axle case
0.28L
（
0.072U.S.gals.
）
Oil capacity for
rear axle case
0.20L
（
0.052U.S.gals.
）
Summary of Contents for 550UTV/HS
