OPERATING THE ENGINE 6-2
2.
Set gear shift lever to the “NEUTRAL” position.
①
Gear shift lever.
(H) High Range
(L) Low Range
(N)
“Neutral” position
(R)
“REVERSE”
3. Push the accelerator pedal down slowly.
①
Accelerator pedal
②
Accelerator pedal depressed
1. Insert the key into the key switch and turn it to
START. (Starts the engine.)
OFF (Stops the engine)
ON (Engine runs or headlights on)
◆
Display and Warning Lights
1. When the key is turned to
“START”, lamps (1
engine oil pressure) should come on. If trouble
codes occur at any location with the engine
running, the warning lamp corresponding to
that location comes on.
2. The parking brake warning lamp (2 parking
brake) comes on while parking brake is
applied and goes off when it is released.
IMPORTANT
Relying on the engine warning lights is never
enough. Never fail to conduct daily checks
carefully by referring to Pre Operation Check “ in
“PERIODIC SERVICE” section.
3. Turn the key to the
“START” position and
release when the engine starts.
IMPORTANT:
Because of safety devices, the engine will not
start except when the gear shift lever is placed
in the “NEUTRAL” position and the brake is
depressed.
■
Cold Starting
When
the
ambient
temperature
is
below
-15
℃
( 5
℉
), and the engine is very cold. If the
engine fails to start after 5 seconds, turn off the key
for 30 seconds and start again.
Summary of Contents for STRIKE 1000
