PERIODIC SERVICE 10-4
·
A special wrench can be obtained at a HiSUN
dealer to make this adjustment.
·
The spring preload setting is determined by
measuring distance A, shown in the illustration.
The shorter distance A is, the lower the spring
preload; the longer distance A is, the higher the
spring preload with each complete turn of the
adjusting nut.
Spring Preload Setting(Front)
Minimum(soft): 332mm(13.07 in)
Maximum(hard): 442mm(17.40in)
Spring travel setting(Rear)
Minimum(soft): 402mm(15.83in)
Maximum(hard): 502mm(19.76 in)
NOTE:
Always tighten the locknut against the adjusting
nut, and then tighten it to the specified torque.
Rebound damping force
Turn the rebound damping force adjusting screw in
direction
S
to increase the rebound damping force
and thereby harden the damping, and in direction
F
to decrease the rebound damping force and
thereby soften the damping.
1. Rebound damping force adjusting screw
Compression damping force
Turn the compression damping force adjusting
screw (use 3.0 Allen wrench) in direction
ⓐ
to
increase the compression damping force and
thereby harden the damping, and in direction
ⓑ
to
decrease the compression damping force and
thereby soften the damping.
1. Compression damping force adjusting screw
WARNING
·
Suspension components become hot
during operation. Never touch the
compression damping force adjusting
screw, the rebound damping force
adjusting screw or the oil reservoir with
your bare hand or skin until suspension
components have cooled.
·
Always adjust the shock absorber
assemblies on the left and right side to
the same setting. Uneven adjustment can
cause poor handling and loss of stability,
which could lead to an accident.
1. Locknut 2. Spring preload adjusting nut
3. Special wrench
.
Summary of Contents for STRIKE 1000
