PERIODIC SERVICE 10-7
IMPORTANT
Radiator screen must be cleaned from debris
to prevent engine from overheating
■
Checking brake fluid level
CAUTION
TO avoid personal injury:
Never operate the vehicle if the brake fluid
is below the minimum mark.
Use only DOT3 from a sealed container.
Other types of brake fluid may ruin
synthetic resin or rubber installed in brake
system components and may cause brake
failure.
Avoid contamination of the brake fluid
thoroughly clean before removing the filler
cap. Do not open the brake fluid reservoir
cap unless absolutely necessary.
Use extreme care when filling the reservoir.
If brake fluid spills on the power steering
hose, wash it off with water immediately, as
brake fluid quickly ruins synthetic resin or
rubber hoses.
1. Park the vehicle on a level ground and open
the hood.
2. Check to see that the brake fluid level is up to
the LOWER mark.
3. If
it is below the “LOWER” mark add brake
fluid .
①
Upper Level
②
LOWER Level
■
Checking brake pedal
CAUTION
TO avoid personal injury:
Stop the engine and chock the wheels
before checking brake pedal.
1. Inspect the brake pedal for free play and smooth
operation.
Adjust if incorrect free play is found. (see checking
brake pedal in” EVERY 200 HOURS in PERIODIC
SERVICE section)
①
Brake pedal
②
FREE TRAVEL
■
Checking parking brake
Pull the parking brake lever to apply the brakes
with the key switch in the "ON" position and the
parking brake indicator should come on.
To release the brake, push in the button on the tip
of the parking brake lever and tilt the lever down.
NOTE
Make sure the parking brake warning lamp on the
display goes off when parking brake lever is down.
Summary of Contents for STRIKE 1000
