Hitachi Koki C 7SB2, Handling Instructions Manual

10

35. Blades and accessories must be securely mounted to the tool.

Prevent potential injuries to youself or others. Blades, cutting implements and
accessories which have been mounted to the tool should be secure and tight.

36. Never use a tool which is defective or operating abnormally.

If the tool appears to be operating unusually, making strange noises, or otherwise
appears defective, stop using it immediately and arrange for repairs by a Hitachi
authorized service center.

37. Carefully handle power tools.

Should a power tool be dropped or struck against hard materials inadvertently, it may
be deformed, cracked, or damaged.

38. Do not wipe plastic parts with solvent.

Solvents such as gasoline, thinner, benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dried
thoroughly.

39. Never wear gloves made of material liable to roll up such as cotton, wool, cloth or

string, etc.

40. Appropriate Blade for C7SB2 Circular Saw

For model C7SB2, the saw blade’s diameters which can be mounted are from maximum
185 mm to minimum 180 mm.
Do not use saw blades made of high speed steel.

41. Definitions for symbols

V ............ volts
Hz .......... hertz
A ............ amperes

n

o

.......... no load speed
.......... Class 

II

 Construction

---/min ... revolutions per minute

........ alternating current