15
English
7. Using depth gauge (Fig. 14)
(1) Loosen the knob on the side handle, and
insert the depth gauge into the mounting
hole on the side handle.
(2) Adjust the depth gauge position
according to the depth of the hole and
tighten the knob bolt securely.
8. How to use the drill bit (taper shank)
and the taper shank adaptor
(1) Mount the taper shank adaptor to the
rotary hammer. (Fig. 15)
(2) Mount the drill bit (taper shank) to the
taper shank adaptor. (Fig. 15)
(3) Turn the switch ON, and drill a hole in
prescribed depth.
(4) To remove the drill bit (taper shank),
insert the cotter into the slot of the taper
shank adaptor and strike the head of the
cotter with a manual hammer supporting
on the rests. (Fig. 16)
Grip
Fig. 13
Fig. 15
Drill Bit
Taper Shank
Adaptor
Front Cap
Grip
Knob on Side
Handle
Cotter
Rests
Taper Snank Adaptor
Fig. 16
Fig. 14
Mounting
Hole
Depth
Gauge
