OPERATION OF REMOTE CONTROL
37
connected.
• The external VIDEO INPUT mode will change as follows each time the
INPUT
is pressed.
• INPUT mode can be selected by pressing either the
CH UP (
)
on the TV remote control when the TV is set to
the highest channel stored in memory, or by pressing the
CH DOWN (
)
when it is set to the lowest channel.
NOTE:
• When connecting video or audio equipment to the television, be sure that the power is turned off in order to
prevent damage to either the television or the equipment being connected.
• The S-VIDEO terminal has priority over a VIDEO terminal (IN-1). When you want to watch pictures from video
equipment connected to a VIDEO terminal, unplug equipment connected to the corresponding S-VIDEO terminal.
• It is the intent of HITACHI that this product be used in full compliance with the copyright law and that prior
permission be obtained from copyright owners whenever necessary.
• For detailed information on the connection and use of auxiliary equipment, refer to the instruction manuals of the
equipment being used.
• The connection cords can be obtained from your local video store.
OPERATION OF REMOTE CONTROL
UNIVERAL REMOTE CONTROL
With the purchase of your television set you also have received the latest innovation in remote control technology.
With its easy-to-use push-button keypad, your Remote can control your television set and most infrared remote-
controlled VCRs and cable TV converters as well.
NOTE:
• Depending on the model, year produced, brand and type of VCR, some models may not be compatible with the
remote control.
• Some brands of VCR or Cable TV converter Box may not enable channel selection until the ENTER is pressed.
Example:
When you select channel 24,
(1) Press REMOTE KEYPAD "2".
(2) Press REMOTE KEYPAD "2".
(3) Press ENTER.
For detailed information on the use of the VCR or Cable TV converter Box refer to their operating manuals.
USING YOUR REMOTE WITH YOUR TV
After installing the batteries, set the
TV-CATV
on the remote to the TV position. (If you can change the channel of
the TV by pressing
CH UP (
)
or
DOWN (
)
on the Remote Control, it is in the TV position.)
"IDENTIFYING" REMOTE VCR AND CABLE TV CONVERTERS
Your Remote Control has been set at the factory to operate your TV and many remote control VCRs and Cable
Converters. However, in some cases an easy one-tiem set-up step may be necessary before the Remote will
operate accessory VCRs and Cable Converters.
• In this set-up step, the Remote locates and memorizes the remote control transmitter code for the VCR or Cable
Converter.
• Once "identified", the Remote sends the proper remote signals to operate your accessory.
• This identify step will not have to be repeated until power to the Remote is interrupted due to a battery failure.
USING YOUR REMOTE CONTROL WITH A VCR
Once you make certain the Remote Control has "identified" your remote controlled VCR, the Remote Control is
ready to operate your unit. The various VCR function buttons on the Remote Control will not operate your VCR if
those features are not already found on your unit.
