TIPS ON REAR PANEL CONNECTIONS
S-Video connections are provided for high performance laserdisc players, VCRs etc., that have this feature. Use
these connections in place of the standard video connection if your device has this feature.
If your device has only one audio output (mono sound), connect it to the left audio jack on the TV.
Refer to the operating guide of your other electronic equipment for additional information on connecting your
hook-up cables.
A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line
output. (INPUT 1 in example on page 11.) Refer to your VCR operating guide for more information on line input-
output connection.
You may use VIDEO or COMPONENT VIDEO: Y-CB-CR inputs to connect to INPUT 2, but only one of these
may be used at a time.
Connect only 1 component to each input jack.
COMPONENT VIDEO: Y-CB-CR connections are provided for high performance components, such as DVD
players. Use these connections in place of the standard video connection if your device has this feature.
When using the Y-CB-CR input jacks, connect your components audio output to the TV's INPUT 2 Left and Right
Audio input jacks.
Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the
TV's CB input and the components R-Y output to the TV's CR input.
It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-CB-CR inputs. (See pages
47 and 48.)
To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using Y-CB-CR jacks.
When using the Y-CB-CR jacks, INPUT 2 will be viewed as a blank PIP sub-picture. (see page 22)
EXTERNAL CONNECTIONS
CONNECTING EXTERNAL AUDIO AMPLIFIER
To control the audio level of an external audio amplifier with the remote control, connect the system as shown
below.
