Use the number buttons to select which point to adjust: (1) - Upper Left, (2) - Upper Middle, (3) - Upper Right, (4) -
Center Left, (5) - Center, (6) - Center Right, (7) - Bottom Left, (8) - Bottom Middle, (9) - Bottom Right.
Press the CURSOR buttons to move the displayed color up, down, left, or right.
Press MENU to change the color you want to adjust.
Press the front panel DIGITAL ARRAY button or the remote control MOVE button when adjustment is done. This
will save your adjustment into memory.
NOTES: Only a momentary press of the DIGITAL ARRAY button is necessary to enter DIGITAL ARRAY
convergence adjustment mode.
Do not press the DIGITAL ARRAY button for more than three seconds. This is only for extreme cases of
misconvergence and requires assistance from service.
Four lines surrounding a crosshatch indicate the point being adjusted. The color of these surrounding lines
indicates the color being adjusted.
To save your adjustment data into memory, press the front panel DIGITAL ARRAY button or the remote control
MOVE Button. If you do NOT wish to save your adjustment data into memory, turn the TV OFF or press the
remote control PIP button. When the TV is turned ON again, your old convergence data will be stored.
When adjusting convergence, always start at the center of the screen.
CUSTOM
This selection contains advanced features which will make TV viewing easier and more enjoyable.
CHANNEL ID
Use this feature to give up to 20 channels a name when ANTENNA signal source is selected and up to 60
channels a name when CATV1 signal source is selected.
