Recommended liquid gasket
1. Using the thread liquid gasket
Type
Product name
Manufacturer
Location of use (Reference)
Silicon type
(Room-
temperature
vulcanized)
ThreeBond 1207B
ThreeBond 1207C
ThreeBond 1215
ThreeBond 1216
ThreeBond
ThreeBond
ThreeBond
ThreeBond
Engine oil seal retainer
Engine oil pan
Timing gear case
Cylinder head cover
Fuel pump
Water pump
etc.
Water soluble
ThreeBond 1141
ThreeBond
Solvent based
ThreeBond 1104
ThreeBond 1194
ThreeBond
ThreeBond
Anaerobic
Loctite 515
Loctite 518
FMD127
（
Loctite 5127
）
Loctite 271
Loctite
Loctite
Loctite
Loctite
Loctite
Engine oil seal retainer
Water pump
Plug
etc.
Caution
：
・
Make sure to use a liquid gasket with the
product name above or equivalent.
・
Use an appropriate amount of liquid gasket.
・
Follow the handling precautions for the
product.
・
Do not use LOCTITE 515, 518, or FMD 127
(Loctite 5127) as they are anaerobic and do
not provide sufficient effect if there is a gap
larger than 0.25 mm {0.0098 in} between the
contact surfaces of metals.
Whenever disassembling, completely remove the old
liquid gasket on the parts and the mating parts where the
liquid gasket was used using a scraper, and clean using a
waste cloth, etc., so that any oil, moisture, dirt, etc., is
removed. After cleaning, apply the specified liquid gasket
to each location and assemble.
Note
：
・
If a gasket remover is used to make the
operation during cleaning easier, it is better to
wait approximately 10 minutes after applying
before starting the removal operation.
Caution
：
・
Do not apply a gasket remover to the plastic
parts and the painted parts.
Thoroughly apply a liquid gasket with the specified bead
width to one side of the contact surface.
Caution
：
・
Be careful not to excessively or insufficiently
apply liquid gasket.
・
Be sure to overlap the start and end of the
liquid gasket application.
・
Be careful not to misalign the part with the
mating part when assembling applied parts.
Note
：
・
Apply again if there is a misalignment.
・
Use the same size studs as a guide when
using for a section which has no positioning
such as a dowel pin.
Caution
：
・
After applying a liquid gasket, assemble within
15 minutes.
Note
：
・
When more than 15 minutes have passed after
applying a liquid gasket, remove the liquid
gasket and apply it again.
Caution
：
・
Wait at least 30 minutes before starting the
engine after assembling each part.
14A-6 Service Information Guide (All)
