7.13.3
Timer and schedule configuration
?
N O T E
Timer settings are only valid if the corresponding zone is in ON state at the time of execution of the respective timer program.
The LCD controller must be set to the correct date and time before using the timer function.
Select the desired area to apply the timer function or delete all timers configuration:
Heating/Cooling (Water):
To set
the timer to adjust the water working
conditions for Circuit 1/2.
Heating/Cooling (Air):
To set the
timer to adjust the room temperature
for Room 1/2. Only when using room
thermostats.
Is possible to launch a timer assistant.
To set the timer to adjust the hot water
tank temperature.
To set the timer to adjust the swimming
pool temperature.
Press OK button to reset scheduled
timers.
To set the
Override type
:
•
Until next action
•
Specific time
•
Forever
1 / 2
2 / 2
When a timer is being switched on, if that zone is stopped, it will request to switch on the zone or not.
UNIT CONTROLLER
PMML0575 rev.1 - 09/2021
78
