12
How to Install the Washing Machine (Continue)
●
The symbol
M
is for checking whether you install the washing machine correctly.
Connecting the water supply
●
Water supply hose
M
Optimum water pressure is 0.03-0.8MPa.
M
Do not connect to the mixer tap of an unpressurised hot-water apparatus.
M
Use a horizontal tap.
Horizontal tap
Extension tap
Square tap
M
Connect the water supply hose to the rear panel of the washing machine.
Make sure that the rubber seal is inside the hose connector.
Hose connector
Rubber seal
* Model with SCREW TYPE water supply hose.
min. 10 mm
M
Firmly connect the water supply hose to the tap, and check connection points
for water-tightness.
* Model with ONE TOUCH JOINT water supply hose.
1.
Untighten the upper connector screw.
Upper connector
Rubber packing
Middle connector
Fixing screw
●
In case the diameter of the tap is large, remove
the guide plate.
Guide plate
Connector
2.
Push the upper connector up till the rubber
packing is in tight contact with the tap.
Then tighten the 4 screws.
Rubber packing
Upper connector
Middle connector
●
Turn the middle connector so that there is
no water leak.
3.
Connect the water supply hose to the middle
connector, pushing the plate down.
Middle connector
Water supply hose
●
To separate the water supply hose from the
middle connector, turn off the tap, and then
pull the inlet hose down, pushing the plate
down.
Summary of Contents for BD-100GV
Page 67: ...67 Memo ...
Page 68: ...3WPL147262 ...