61
Pa
rt
ia
l O
p
e
ra
tio
n of t
h
e FU
Z
Z
Y Pr
o
g
ra
m
En
g
lish
pressing its
Resulting operation
Set the
<HOT WASH>
function.
(When not
using this
function, skip
to
)
Ú
Do not use the
<HOT WASH>
function when
starching
laundry.
WASH
DRY
Available
The wash to spin cycles
operate according to your
settings.
Not available
The laundry water is drained
before operation stops.
WASH
DRY
Available
The rinse water remains
when the operation stops.
Not available
Press the
<START>
button.
Washing and spinning is
performed without rinsing.
Not available
WASH
DRY
Available
Drainage and spinning is
performed before the rinse,
and rinse water remains
when the operation stops.
Drainage and spinning is
performed before the rinse,
and spinning is performed
again after rinse.
Not available
Drainage is performed
before spinning.
You can change the wash, rinse, and spin cycle settings and use different combinations for
operation.
(Setting changes cannot be saved.)
You can save frequently used setting combinations by setting the [FAVORITE] program.
(P. 58)
z
If water remains in the drum, run the spin cycle in the [FUZZY] program for 1 minute before operation.
If you start an operation with water already inside the drum (3 L or more), the wash load size may not be
detected, the detergent indicator may not display, and the <HOT WASH> function may not operate.
z
Do not reuse laundry water.
Doing so may result in excessive foaming and malfunction.
z
When only the <WASH> cycle is set, you can pause the operation, but you cannot add the <RINSE> or <SPIN>
cycles or change settings such as the wash time.
z
When only the <SPIN> cycle is set, the remaining time display will be longer than the spin cycle time setting.
(This is because water drainage and correction of uneven distribution for the spin operation consume time.)
You can perform partial operation of programs other than [FUZZY] by pressing the buttons for
the cycles you do not want to use and turning off their indicators. (This is not possible in some
programs.)
(P. 64, 65)
