62
Using the DELAY START Function
How to change the delay time
The delay time indicates the time at which the operation will finish.
For example, if you want the operation to finish three hours later, set the delay time to 3 hours.
The setting changes with each press of the <DELAY START> button.
Operation finishes 3 hours later
3 to 12 hours later
For <<WASH>> operations
For <STEAM IRON> operation
5 to 12 hours later
For <<WASH DRY>> operations
Initial settings
N
o
t s
e
t
12
H
R
L
A
T
E
R
11
H
R
L
A
T
E
R
6 H
R
L
A
T
E
R
5 H
R
L
A
T
E
R
4 H
R
L
A
T
E
R
3 H
R
L
A
T
E
R
<<WASH>>
<<WASH DRY>>
The [BLANKET], [DELICATE] and [TUB CLEAN] wash programs and the <<DRY>> operations
cannot be delayed.
After setting the delay
z
To check the delay time:
Press the <DELAY START> button.
(The delay time appears while the button is pressed.)
z
To cancel the delay:
Press the <OFF> button to turn off the power.
z
To change the delay time: Press the <OFF> button to turn off the power, and start over.
z
To add laundry:
Add the laundry without turning the power off.
z
The time at which the operation finishes may vary depending on the volume and type of laundry,
amount of water, water and air temperature, and drainage conditions.
z
Do not wash laundry with items that are likely to bleed color using delayed operations.
z
If the power plug is disconnected or a power outage occurs, the delay will be canceled.
z
To reduce wrinkles, hang laundry as soon as possible after the operation finishes.
z
The <PAUSE> button will be disabled until the <DELAY START> operation starts.
z
Remove the laundry as soon as possible after the operation finishes.
Leaving the laundry inside after the operation finishes can result in odors.
We recommend using the Fluffy Clothes function for delayed <<WASH DRY>> operations.
(P. 73)
z
Do not add too much laundry after setting the delay time.
Doing so may reduce washing results and result in uneven drying.
z
Even if you set a delay, the operation for large wash loads may start immediately after you press the
<START> button due to the longer operation time required for large loads.
