72
Other Settings
(continued)
Using the HOT WASH function to remove stubborn stains
After spraying concentrated detergent onto the laundry, warm air is blown to activate the
detergent for more complete cleaning.
Enable the
<HOT WASH>
function.
Detergent
is
dissolved.
Detergent
is injected.
Detergent
is warmed.
Beat
washing
starts.
Ú
Operation
time will
increase
by about
13 minutes.
The
circulation
pump
dissolves the
detergent.
The
detergent
is sprayed
onto the
laundry in a
concentrated
state.
Warm air is
blown onto
the laundry
to activate
the cleaning
enzymes in
the detergent
and break up
stains.
Water is
added, and
detergent
that is about
twice as
concentrated
as in normal
operation is
circulated.
Warm
air
Circulation
pump
z
Circulation
alternates
between
warm
air and
detergent
circulation.
z
When the <HOT WASH> function is used, the operation time will be about 13 minutes longer than usual, and
more power will be consumed.
z
During operation, the [HOT WASH] indicator will blink for about 10 minutes and then turn off.
z
If you press the <PAUSE> button during the <HOT WASH> operation, the door lock may not be released
immediately.
The inside of the drum is cooling down in such cases.
z
In low-temperature environments (about 8°C or lower), the <HOT WASH> operation may take about 2 minutes
longer.
z
The <HOT WASH> function cannot be used in the following cases:
• If water is already in the drum when you start
• The [BLANKET], [DELICATE], and [TUB CLEAN] programs, and <<DRY>> and <STEAM IRON> operations
z
When the <HOT WASH> function is set, you cannot change any other settings from the time the wash load is
detected and until the <HOT WASH> operation finishes.
z
If you pause during a <HOT WASH> operation, the
indicator may light even if the door lock is released.