74
Other Settings
(continued)
Changing the dehumidification mode
You can change the method of dehumidification used during drying operations.
z
Air Cooling Mode: Expels moisture and warm air from the drain hose during drying operations.
z
Water Cooling Mode: Uses water for dehumidification during drying operations. (More water is consumed.)
You cannot set the dehumidification mode to Water Cooling Mode when the [POWER SAVE] or
[POWER SAVE STATIC DRY] program is set. Similarly, you cannot select the [POWER SAVE] or
[POWER SAVE STATIC DRY] program when Water Cooling Mode is set.
To change the default setting
Press <ON> to turn on the power.
When the setting is changed, it is notified by the
following indicators and beep sounds.
Water Cooling Mode
Air Cooling Mode
(default setting)
Short beep sound
Long beep sound
Hold <DRY> for at least 3 seconds.
Press <OFF> to turn off the power.
z
This setting will be saved.
Ú
Water Cooling Mode is always used during the [SILENT], [FUZZY (15 MIN)], and [DEODORANT] programs, and
the <STEAM IRON> operation.
Discharging the residual water in the drain hose
during the AUTO SELF CLEAN operation
Residual water in the drain hose is discharged by passing air through the drain hose during the
<AUTO SELF CLEAN> operation.
To change the default setting
Press <ON> to turn on the power.
When the setting is changed, it is notified by the following
indicators and beep sounds.
Off (default setting)
On
Long beep sound
Short beep sound
Hold <SPIN> for at least 3 seconds.
Press <OFF> to turn off the power.
z
This setting will be saved.
To change the setting, perform the same operation.