83
T
rouble
shooting
Indicator and meaning
Possible cause and solution
Water cannot be supplied.
Press
<PAUSE>
to pause.
z
Make sure the tap is turned on.
z
Make sure the water supply inlet’s filter is not clogged.
(P. 82)
z
Check whether a water outage has occurred.
z
Make sure the water supply pipe or water supply hose is
not frozen.
(P. 103)
Press
<START>
to start
the
operation.
Water cannot be drained.
Press
<PAUSE>
to pause.
z
Make sure the drain hose, drain outlet, or lint filter is not
clogged with lint or other debris.
(P. 76, 82)
z
Make sure the drain hose is installed properly.
(Installation
Instructions)
• Make sure it is not pinched or frozen.
• Make sure it is laying flat.
• Make sure the end of the hose is not submerged in water.
• Make sure it does not rise 10 cm or more above the
ground at any point.
z
When using an extension hose, make sure the hose does
not exceed 5 m in length.
Press
<START>
to start
the
operation.
The door is open.
Press
<PAUSE>
to pause.
z
Close the door.
For safety, the door is locked when the drum is rotating.
z
Make sure the door stopper is retracted.
Use a coin or similar object to turn the door stopper
counterclockwise until it clicks into place.
z
Make sure you released your hand from the door handle.
Put the door handle back to its original state.
After
closing
the door,
press
<START>
to start the
operation.
Spinning is not possible.
Press
<PAUSE>
to pause.
z
Make sure the laundry is not concentrated on one side.
Distribute the laundry in the drum as evenly as possible.
(Even if it appears even, items made of cotton, for
example, can become heavy with water, causing
imbalance if concentrated in one area.)
z
Do not wash thick items (cotton blankets, jeans, etc.) or
items in mesh laundry bags alone.
Add 2 or 3 more items, and wash together. (Single pieces
of laundry tend to gravitate to one side.)
(P. 20 to 23)
z
Do not wash too many sheets or large items at one time.
Reduce the number of large items.
(P. 20 to 23)
z
Make sure the machine is stable and installed on a level
surface.
Make sure the air bubble in the spirit level is inside the
circle.
(Installation Instructions)
z
Do not load items that cannot be washed or dried.
Remove items that cannot be washed or dried.
(P. 18)
Such items can increase the vibration during the spin
cycle.
Press
<START>
to start
the
operation.
Troubleshooting
Error codes in the remaining time indicator
Note on Auto
Power Off
z
If you turn the power on and do not start an operation within 10 minutes, the power will turn
off automatically.
z
If the machine remains in the pause state for more than 1 hour, the power will turn off
automatically. (The power will turn off automatically if the machine remains in the pause
state for 15 minutes during drying operations.)
z
The power turns off automatically after an operation finishes.
z
If the error code is left displayed for more than 12 hours, the power turns off automatically.
z
In the following cases, the indicator will blink and a buzzer will be emitted.
Press the <PAUSE> or <OFF> button to stop the operation, and then press the <START> or <ON> button to
restart the operation.
If the error code continues to appear, check the “Possible cause and solution” column below.
Ú
For details on displays not described below, see
(P. 96, 97)
.
En
g
lish
