97
T
rouble
shooting
Symptom
Possible cause
Solution
Rema
ining
time
indicat
or
[TUB COOLING] is
displayed.
Did you press the <PAUSE> button during
drying operations?
z
The drum cooling operation is being performed,
as the inside of the drum becomes hot during
drying operations.
This is not a malfunction.
The remaining time
indicator blinks
and does not
decrease during
drying operations.
z
Operations may extend 1 to 2 hours after the
[TIME LEFT 10 MIN] indicator appears. This
occurs automatically when the machine detects
that the laundry is not sufficiently dry.
This is not a malfunction.
The remaining
time indicator
blinks after spin
operations.
Is the Tangle-Free Finish function set?
z
This indicator display occurs during the
untangle process after spin operations.
The power turns off automatically when you
press the <PAUSE> button, allowing you to
remove the laundry.
For details on the Tangle-Free Finish setting, see
(P. 73)
.
Are you running the [SOFT] program?
z
This indicator display occurs while warm air is
blowing onto laundry during spin operations.
This is not a malfunction.
The remaining
time indicator is
longer than the set
spinning time.
z
In addition to the actual operation time, the
remaining time indicator also includes the
time used for the correction of uneven laundry
distribution, the acceleration of the drum, etc.
This is not a malfunction.
The remaining time
indicator displayed
immediately after
the operation starts
is longer than that
of the previous
operation.
z
If the water pressure was low during the
previous operation (i.e., the water supply was
slow), the displayed time will be extended to
compensate for the longer water supply time.
This is not a malfunction.
z
Is the water supply inlet’s filter clogged?
Clean the water supply inlet.
(P. 82)
[TIME LEFT 1 MIN]
is displayed for a
longer time.
Are you running the <STEAM IRON> operation?
z
This is because the drum cooling (fan) operation
is prolonged to cool down the temperature of
the inside of the drum.
This is not a malfunction.
L
iq
u
id
c
ry
s
ta
l d
is
p
la
y (
b
a
c
k
lig
h
t)
The liquid crystal
display (LCD) is
hard to see (too
dark/bright)
z
You may have some difficulty seeing the LCD
depending on the viewing angle, installation
environment, and surrounding conditions.
This is not a malfunction.
The LCD backlight
is not lit.
Is the <DELAY START> function set?
z
The backlight is off when a delay time is set and
the machine is in standby mode.
The backlight turns on when you press and
hold the <DELAY START> button to check the
setting.
This is not a malfunction.
For details on the <DELAY START> setting, see
(P. 62)
.
Is the backlight auto-off function enabled?
z
If so, the backlight will turn on and remain lit for
3 minutes whenever you press a button.
Disable the backlight auto-off function.
(P. 70)
Indicators on the
LCD become sharp
or dim during
operations.
z
It is a characteristic of the liquid crystal display
that image sharpness changes depending on
the viewing angle and display content.
This is not a malfunction.
A part of the LCD
turns black.
z
If you wipe the control panel with a dry cloth,
a part of the LCD may turn black due to static
electricity.
This is not a malfunction.
The phenomenon will soon disappear by itself.
En
g
lish
