29
Problem
Possible Cause
Solution
Foam remains
on the door or
the door seal.
●
You may have used too much detergent.
●
Laundry is new or not that soiled.
●
Use the appropriate amount of
detergent.
Fabric softener
over
fl
ows.
●
You may have exceeded the max. level of
softener in the detergent case.
●
Do not pour in more than the
max. level of softener.
Fabric softener
remains.
●
The softener cover may have come out.
●
Firmly set the softener cover
on the detergent case.
There is
detergent
powder residue
in the detergent
case.
●
You may have used too much detergent.
●
You may have poured detergent in the
detergent case when it was wet. Wipe the
water away before adding detergent.
●
Use the appropriate amount of
detergent.
●
Wipe the water away before
adding detergent.
The washer
dryer switches
off during
operation.
●
There may be noise from other electrical
appliances nearby such as a TV, a radio,
etc.
●
The motor may be locked due to overload,
the clothes being trapped in the rubber seal,
etc.
●
Unplug the power cord and
plug in again. Then select
a program and start. Do not
place electrical appliances
close to the washer dryer.
●
This is not a malfunction. Wait
for about one hour and restart
the program.
Odor in the
washer dryer
●
Rubber parts may give off a smell when you
fi
rst start using the washer dryer.
●
There may be mold, dirt or detergent
residue on the drum.
●
The smell goes away over
time.
●
Run the Tub Clean program.
Unsatisfactory
washing results
●
You may have used too few detergent.
●
You may have poured detergent directly into
the drum.
●
Use the appropriate amount of
detergent.
●
Pour detergent in the
appropriate dispenser.
Unusual noise or
vibration
●
The transport bolts may not have been
removed.
●
The washer dryer may be installed on a
sloping or unstable surface.
●
There may be foreign objects inside the
drum.
●
Remove the transport bolts
before using.
●
Install the washer dryer on a
horizontal, stable surface.
●
Remove foreign objects such as
coins, pins, etc. from the drum.
There is sound of
water when the drum
is rotated manually.
●
This is normal. Liquid is inside the 4-Ply
Liquid Load Balancer
fi
xed onto the drum to
make it balanced.
●
This is not a malfunction.
Tapping noise
comes out at
spin start.
●
This is normal. Tapping sound is generated
when laundry touches to the laundry
protection bulge on the laundry inlet.
●
This is not a malfunction.
Detergent case
is wet.
●
In some environmental or usage conditions,
Detergent case may get wet due to
condensation.
●
This is not a malfunction.
Water remains
in washer dryer
before initial use.
●
There may be drops of water or
condensation in the washer dryer due to the
factory inspection prior to shipment.
●
This is not a malfunction.
BD-SG100CJ_OM&IM_EN.indd 29
BD-SG100CJ_OM&IM_EN.indd 29
2019/5/13 14:22:27
2019/5/13 14:22:27
