33
CAUTION
Do not move or install the washer
dryer by yourself without anyone’s
help.
If the washer dryer is forcibly moved, it
may fall over and injury may result.
Water may leak
if any one-touch
joint other than
that supplied is
used.
Water may leak
if any screw
or connector becomes loose after using
the washer dryer for an extended period.
Please regularly check the connection and
tighten in case of looseness.
Always use the supplied water supply hose
and one-touch joint.
Use the supplied one-touch joint and
tightly fasten connector
B
.
(After tightening)
About 4 mm
or less
Connector B
During installation, do not let the drain
hose slacken inside the washer dryer.
Unless the hose is taut inside the washer
dryer, it could come in contact with other
components, resulting in hose damage,
water leakage, and unforeseeable damage.
Tightly fasten the union nut of the
water supply hose to the washer
dryer.
Water leakage may occur if the nut is not
tight.
If the union nut becomes loose after
extended use, water leakage may occur,
leading to unexpected damage. Please
regularly check
the union nut and
tighten it in case of
any looseness.
Union nut
When changing the connection
to the water tap after installing or
moving the washer dryer, turn on
the tap and check for water leakage
before operating the washer dryer.
Loose screws may result in water leakage or
unforeseeable damage.
Do not use hot water from an
on-demand water heater
The temperature of water supplied by
on-demand heaters can momentarily
exceed 50°C, possibly harming the
washer dryer parts and leading to water
leakage that may cause damage.
Prohibited
Check
Check
Water
leakage
Water
leakage
Air entrapped in the water supply hose can
cause water to spill at the detergent case. After
installation is completed or after every time the
water supply hose is disconnected, open the water
tap slowly after the detergent quantity is displayed.
Note that water spillage may occur
due to air entrapped in the water
supply hose after installation or
following water supply outages.
Water
spillage
Water
leakage
Water
leakage
Prohibited
Connecting the
power
■
Connect the washer dryer to an alternating current via a correctly
installed earthed socket only.
■
The mains voltage must correspond to the voltage speci
fi
cation on the
washer dryer.
■
Connection speci
fi
cations as well as the required fuses are stipulated
on the washer dryer nameplate.
■
Do not plug the washer dryer into an extension lead or power strip with
multiple sockets.
BD-SG100CJ_OM&IM_EN.indd 33
BD-SG100CJ_OM&IM_EN.indd 33
2019/5/13 14:22:27
2019/5/13 14:22:27
