14
English
Sub fence (C)
Fence (B)
Knob (B)
In the case of left bevel angle cutting, remove the sub fence (C) by
sliding to the side and removing from the top as shown in Fig. 13.
Loosen knob (B) then remove the sub fence (C) (Fig. 14)
WARNING:
To attach the sub fence (C), insert then securely
tighten knob (B).
If knob (B) is loose, the sub fence (C) may move
during cutting and result in injury.
Fig. 14
8. Position adjustment of laser line
WARNING:
* Make sure before plugging the power plug into the receptacle that the main body
and the laser marker are turned off.
* Exercise utmost caution in handling a switch trigger for the position adjustment of
the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in
unexpected accidents.
* Do not remove the laser marker to be used for other purposes.
CAUTION:
Fig. 15
Fig. 16
* Laser radiation- Do not stare into beam.
* Laser radiation on work table. Do not stare into beam.
If your eye is exposed directly to the laser beam, it can be hurt.
* Do not dismantle it.
* Do not give strong impact to the laser marker (main body of tool); otherwise, the
position of a laser line can go out of order, resulting in the damage of the laser
marker as well as a shortened service life.
* Keep the laser marker lit only during a cutting operation. Prolonged lighting of the
laser marker can result in a shortened service life.
* Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
NOTE:
* Perform cutting by overlapping the ink line with the laser line.
* When the ink line and the laser line are overlapped, the strength and weakness of light will
change, resulting in a stable cutting operation because you can easily discern the conformity
of lines. This ensures the minimum cutting errors.
* In outdoor or near-the-window operations, it may become difficult to observe the laser line
due to the sunlight. Under such circumstances, move to a place that is not directly under the
sunlight and engage in the operation.
* Do not tug on the cord behind the motor head or hook your finger, wood and the like around
it; otherwise, the cord may come off and the laser marker may not be lit up.
* The laser marker will not light up if the digital display switch is turned off. (only on C12LDH)
01Eng_C12LDH_US
12/27/10, 13:18
14
