13
English
Stopper
Holder
6 mm Wing Bolt
Fig. 10
5. Stopper for precision cutting (Standard accessory)
The stopper facilitates continuous precision cutting in lengths of
11 - 5/8" to 18 - 1/2" (295 mm to 470 mm).
To install the stopper, attach it to the holder with the 6 mm wing
bolt as shown in Fig. 10.
6. Handle position adjustment
During cutting operation, adjusting the upper limit 10mm depth
adjustment bolt according to workpiece height as illustrated in Fig.
11, reduces the up - down handle movement range for a higher
operating efficiency.
Loosen the 10 mm lock nut which fixes the upper limit 10mm depth
adjustment bolt and move the handle up and down to allow the
10mm depth adjustment bolt to be set in a position suitable for the
height of the workpiece to be cut. Then tighten the 10 mm lock nut.
7. Using an ink line
For cutting along a pre - marked line on the workpiece, lift the safety
cover by operating the lever as shown in Fig. 12, and align the saw
blade with the pre - marked line, before starting cutting operation.
WARNING:
Never operate the lever while the saw blade is rotating.
Fig. 11
Upper Limit
10mm Depth
Adjustment Bolt
Fig. 12
Lever
Summary of Contents for C 15FB
