– 10 –
English
ESTIMATED ASSEMBLY TIME 40~50 MINUTES
For your own safety, never connect the plug to
power source outlet until all assembly steps are
completed and you have read and understood the
safety and operational instructions.
NOTE:
●
The saw head assembly have been factory
assembled for saving your time.
●
Follow the assembly instruction and carefully
assemble the machine with the help of the second
person.
INSTALLING THE DUST COLLECTOR JOINT (FIG. A)
1. Place protective corrugated cardboard or old blanket
on fl oor to protect the saw table surface. Place the
table with saw head assembly up-side down on the
protective material.
2. Attach the dust extraction port (1) to the bottom of
the body shell with four screws.
Fig. A
INSTALLING THE STAND ASSEMBLY (FIG. B, C)
1. Attach the four legs (2) to the table (1) using the
bolts (3), fl at washers (4) and nuts (5).
NOTE:
●
Front-Left leg with a hole for assembling the
switch (6).
●
Do not tighten bolts until stand is properly
aligned.
ASSEMBLY AND ADJUSTMENTS
WARNING
1
2. Attach the one long bracket (7) to right legs using
bolts, fl at washers and nuts. This completes the
right frame section.
NOTE:
●
Align detents in the legs with brackets to ensure
proper fi t.
●
Position all brackets to the INSIDE of the leg
assembles.
3. Assemble left frame section in exactly the same
way.
4. Join right and left frame assemblies using two short
brackets (8), bolts, fl at washers and nuts.
5. Insert four bolts (9-Fig. C) into brackets, fl at washers
and nuts to fasten the brackets.
6. Insert foot pad (10) into bottom of leg. Repeat for
each leg.
7. Carefully set the saw in its upright position on a
clean and level surface. (Fig. C)
8. Place stand on level surface and adjust so all legs
are contacting the fl oor and are at similar angles to
the fl oor. Tighten the bolts.
NOTE:
Stand should not rock after all bolts are
tightened.
Fig. B
8
3
4
5
2
3
1
10
77
