– 5 –
English
TABLE SAW SAFETY
1.
ALWAYS USE SAW BLADE GUARD
, splitter and
antikickback pawls for every operation for which they
can be used, including through sawing. Through
sawing operations are those in which the blade cuts
completely through the workpiece when ripping or
crosscutting.
2.
ALWAYS HOLD WORK FIRMLY
against the miter
gauge or rip fence.
3.
ALWAYS USE
a push stick, especially when ripping
narrow stock. Refer to ripping instructions in this
Operator’s Manual where the push stick is covered
in detail. A pattern for making your own push stick is
included on page 20.
4.
NEVER PERFORM ANY OPERATION FREEHAND,
which means using only your hands to support
or guide the workpiece. Always use either the
fence or the miter gauge to position and guide
the work.
WARNING: FREEHAND CUTTING IS THE MAJOR
CAUSE OF KICKBACK AND FINGER/HAND
AMPUTATIONS.
5.
NEVER STAND
or have any part of your body in
line with the path of the saw blade. Keep your hands
out of the saw blade path.
6.
NEVER REACH
behind or over the cutting tool for
any reason.
7.
REMOVE
the rip fence when crosscutting.
8.
DO NOT USE
a molding head with this saw.
9.
FEED WORK INTO THE BLADE
against the
direction of rotation only.
10.
NEVER
use the rip fence as a cut-off gauge when
crosscutting.
11.
NEVER ATTEMPT TO FREE A STALLED SAW
BLADE
without fi rst turning the saw
OFF
. Turn
power switch
OFF
immediately to prevent motor
damage.
12.
PROVIDE ADEQUATE SUPPORT
to the rear
and the sides of the saw table for long or wide
workpieces.
13.
AVOID KICKBACKS
(work thrown back towards
you) by keeping the blade sharp, the rip fence
parallel to the saw blade and by keeping the splitter,
anti-kickback pawls and guards in place, aligned
and functioning. Do not release work before passing
it completely beyond the saw blade. Do not rip work
that is twisted, warped or does not have a straight
edge to guide it along the fence.
14.
AVOID AWKWARD OPERATIONS
and hand
positions where a sudden slip could cause your
hand to move into the saw blade.
15.
NEVER USE SOLVENTS
to clean plastic parts.
Solvents could possibly dissolve or otherwise
damage the material. Only a soft damp cloth should
be used to clean plastic parts.
16.
MOUNT
your table saw on a bench or stand
before performing any cutting operations. Refer to
ASSEMBLY AND ADJUSTMENTS
on page 10.
17.
NEVER CUT METALS
or materials that may make
hazardous dust.
18.
ALWAYS USE IN A WELL-VENTILATED AREA
.
Remove sawdust frequently. Clean out sawdust
from the interior of the saw to prevent a potential
fi re hazard. Attach a vacuum to the dust port for
additional sawdust removal.
19.
NEVER LEAVE THE SAW RUNNING
UNATTENDED
. Do not leave the saw until the blade
comes to a complete stop.
20. For proper operation follow the instructions in this
Operator’s Manual entitled
ASSEMBLY AND
ADJUSTMENTS
(Page 10). Failure to provide
sawdust fall-through and removal hole will allow
sawdust to build up in the motor area resulting in a
fi re hazard and potential motor damage.
