3
6
ED-X31E / ED-X33E (C14B-20)
Wiring diagram 3
Assembling of the power unit block
The assembly order of the power block
Assemble the circuit power unit and ballast power unit
(Ballast holder) by the following procedures.
Refer the wiring of the power unit block (Next page) to
style the cables, after you assembled the power unit block.
CNGD1
CNPFC
FEB2
FEB4
CNLAP
CNPFC
FEB2
CNPW
CNPW
TSW
CNGD3
CNGD1
CNGD3
CNGD3
CNPW
TSW
1. Connection of the circuit power unit and the ballast power unit,
Preparation for assembling.
(1) Connect the CNPFC to the circuit power unit.
(2) Pass the CNGD1 and the TSW through the ballast holder hole.
2. Assembling of the circuit power unit and ballast power unit.
(1) Attach the ballast holder to the circuit power unit drawing out the CNPW.
Assemble the ballast holder and the circuit power unit touching the CNPW to
the arrow A side wall of the ballast holder.
You can easily draw out the CNPW.
(2) Draw out the CNPW from the ballast holder hole, then style the CNGD1 and the TSW.
Do not make the excessive length in the power unit.
Do not pull the CNGD1 and the TSW strongly, otherwise connector might be released.
(3) Style the igniter lead (CNLAP) on the ballast sheet.
Make sure not to release the CNLAP from ballast holder hook, then attach the ballast
holder with screws.
Ballast holder
Ballast holder
Ballast power unit
Ballast holder
Ballast power unit
Circuit power unit
Circuit power unit
Ballast sheet
Arrow A
Assemble the ballast holder touching the CNPW
to the arrow A side wall of the ballast holder.
You can easily draw out the CNPW from ballast
holder hole.
Do not make the excessive length in the power unit.
Do not pull the CNGD1 and the TSW strongly.
Make sure not to release
the CNLAP from ballast
holder hook.
< Wiring of CNLAP and CNGD3 >
Never incline the board.
