Figure 5-129 Installing SAS HDD kit
4
.
Close the top cover of the server blade. See
5
.
Install a disk drive.
See
Installing a disk drive on page 5-36
6
.
Install the target server blade.
See
Installing a full-wide server blade on page 5-7
section.
Replacing a management module (redundant)
This procedure describes how to replace the management module under the
redundant configuration. Under this configuration, two management modules
are installed in a chassis.
Removing a management module
1
.
Put on an anti-static wrist strap.
2
.
Web console login procedure on page 4-3
section.
3
.
Turn on LID LED for identifying the target module.
See
Identify LED (LID) on/off procedure on page 4-7
section.
4
.
Turn on the maintenance mode from web console.
See
Maintenance mode on/off procedure on page 4-10
section.
5
.
Identify F/W version and take notes of it.
See
F/W version identification procedure on page 4-22
section.
6
.
Shutdown the failed management module.
5-100
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Summary of Contents for CB 520A A1
