Figure 7-30 LPAR manager System Configuration Screen (3/3)
The following table describes each item on this screen.
Table 7-26 Details of the LPAR manager System Configuration Screen
No.
Item
Description
Default
Value
Supported
LPAR
manager
Version
(1)
LP ID
Sets the ID that identifies LPAR manager
Numbers, in which periods are omitted
from the LP IP Address, are reflected as
the initial value following "LP_".
If you set an IP address in IPv4 format,
"LP_" followed by that LP IP address
excluding periods (.) is applied as the
initial value. If you set only an IP
address in IPv6 format instead, the
numbers between which the colons have
been omitted from the IPv6 address
without omitting the 0's, or the twelve
low-order digits of the IPv6 address in
hexadecimal notation, are reflected
following "LP_".
LP_XXXX
01-0X~
(2)
LP IP Address
(IPv4)
Display LP IP Address
LP IP Address which is set as the
management module is reflected.
-
01-0X~
(3)
Subnet Mask
Display Subnet Mask
Subnet Mask which is set as the
management module is reflected.
-
01-0X~
(4)
Default
Gateway
Sets the IP address of the Default
Gateway.
-
01-0X~
7-64
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide