No.
Configuration information auto save functionality
Supported
version
Disable
Enable
until the configuration information
is saved:
"Because the Configuration
format was updated, saving the
Configuration is necessary. Please
press the F9 key."
(3)
Sends an alert notification about saving of the configuration
information by pressing F9 when F9 is pressed.
01-0X or
later
If you move the cursor to Save Changed Config Format, and then press
Enter, a sub-screen appears. Select Enable or Disable, and then press Enter.
How to change the "LP Timercounter Base" and raise the accuracy
of LPAR manager system time (when not using NTP)
[LPAR manager firmware version 01-3X or later]
Tip:
•
LP TimerCounter Base is displayed when the timer precision of TSC is
lower during operation, you can select TSC or Cpu Frequency. Select the
smaller one for time-lag. LP TimerCounter Base is not displayed when the
timer precision of TSC is higher, TSC is operated.
It is necessary to deactivate all LPARs for changing "LP Timercounter Base".
•
Place the cursor on LP Timercounter Base, and press Enter.
7-112
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide