Message Content
LP detected failed SR-IOV device was assigned to LPAR.
Explanation
LPAR manager detected that the LPAR assigning the isolated PCI
device was activated.
What to do
Since the PCI device is in an error condition, it cannot be used on
LPAR.
When the state of a PCI device is not recovered automatically,
perform the ForceRecovery operation to recover the isolated
state.
Start the guest OS after the PCI device recovery, and the PCI
device can be used again.
Message Content
LP detected initial parameter error.
Explanation
Incorrect data of the initial parameter file was detected.
What to do
Check the settings on the System Configuration screen.
Message Content
LP detected PCI bus error for Shared FC.
Explanation
A PCI bus fault in shared FC was detected.
What to do
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message Content
LP detected PCI dev assign error.
Explanation
LPAR manager detected invalid PCI device assignment.
What to do
Re-allocate the PCI device on the PCI Device Assign screen. If this
LP System Logs is re-obtained, contact the reseller from which
you purchased this equipment or consult maintenance personnel.
Message Content
LP detected too many physical CPUs, some CPUs are
ignored.
Explanation
Ignoring some Processors due to those Processors installed
beyond the maximum number of them LPAR manager can
recognize.
What to do
Contact your reseller or maintenance personnel.
Message Content
LP detected unsupported H/W configuration.
Explanation
A hardware configuration that is not supported was detected.
What to do
A PCI device might be installed on the I/O adapter slot on a PCI
expansion blade. You cannot use such a PCI device because the
PCI expansion blade is not supported.
Message Content
LP detected unsupported settings in the configuration.
Explanation
An invalid value is specified in the configuration information.
9-40
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide