Option
Description
to 3600 seconds. If this option is omitted, the command
will time out in three seconds. If 0 is specified, the
HvmGetPerf command never times out and infinitely waits
for a response from the LPAR manager.
-srcip=IP-address
Specify an IP address on the management server side for
communicating LP IP Address of the sender. This setting is
required for fixing an IP address for HvmGetPerf command
when the management server uses the IP address in the
network configuration, where the server is connected to
multiple segments.
HvmGetPerf: 1.5 or later versions
Output in summary format
If the filename option is omitted, the HvmGetPerf command outputs system
operation overview in summary format. The following figure shows an
example output in summary.
Figure F-1 Output example
The table below describes the information items output in summary format.
Table F-2 outputting items in summary format
Output item
Description
Type option
Header
Outputs the command version and the time at which
operation overview was output.
Always
LPAR manager
system
information
Outputs the IP address and identifier of the target
LPAR manager.
all host
HvmGetPerf Command
F-3
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide