handling can result in injury because the battery can overheat, burst, and
catch fire.
¢
Do not put the battery on charge.
¢
Do not short out the battery.
¢
Do not disassemble the battery.
Storing batteries
When storing batteries, apply adhesive tape on the terminals for
insulation. If the batteries are stored without insulation, the terminals can
contact each other to cause a short-circuit and overheat or burst, leading
to injury or fire.
Precautions against damage to equipment
Insertion of foreign objects into the equipment
Do not allow clips, pins or any other metal items or flammable items to
enter the equipment through a vent or by any other means. Continuing to
operate the equipment with foreign objects could cause failure.
Impact from falling
Do not fall the equipment or hit it against another object. It can cause
internal deformation and deterioration. Operating the equipment under
such defective conditions can cause failure.
Vent
A vent is used for preventing rise in temperature inside the equipment.
Do not block the vent by placing or leaning an object. If you do, the
temperature rises, which can cause failure. Check and clean ventilation
holes periodically to keep the dust from gathering on them.
Contact with connection terminals
Do not touch connection terminals, such as a connector with your hand or
any metal item. Do not insert any objects such as wire into them. Do not
place the equipment in a place with metal pieces. If you do, a short circuit
can be developed, causing equipment failure.
Preface
xvii
Hitachi Compute Blade 500 Series System Service Manual
Summary of Contents for CB 520A A1
