Table 5-7 Recommended display settings
Guest OS
Screen resolution
Color quality
Windows
1024 x 768 pixels
16 bit
Linux
1024 x 768 pixels
16 bit
•
[LPAR manager firmware version: 01-6X or later]
Table 5-8 Recommended display settings
Guest OS
Screen resolution
Color quality
Windows
1024 x 768 pixels
32 bit
Linux
1024 x 768 pixels
24 bit
Display settings for Windows
Note:
•
When using Windows Server 2012 or later in EFI boot, the recommended
display settings are "Screen resolution: 1024 by 768 pixels" and "Color
quality: Highest (32 bit)" on Guest OS.
Display settings cannot be changed.
Set "Screen resolution" to "1024 by 768 pixels", "Color quality" to "Medium
(16 bit)" (When setting 32 bit, set to "Highest (32 bit)") in the Display
Properties dialog box. Click OK.
When the dialog box to confirm is displayed, click Yes.
Display settings for Linux
Note:
•
When setting a display using System > Administration > Display or
System > Preferences > Screen Resolution, the settings of resolution or
color quality might not be reflected normally, or the display might be
distorted after the resolution settings.
In that case, set the display using /etc/X11/xorg.conf.
Open
/etc/X11/xorg.conf
in an editor, and set the following settings.
1
.
Confirm that
Section "Device"
>
Driver
is
vesa
in
/etc/X11/
xorg.conf
.
When other than
vesa
, set
vesa
.
Example of
Section "Device"
settings:
Section "Device"
Identifier "Videocard0"
Driver "vesa"
EndSection
5-64
Setup of LPAR manager
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide