Transfer to Basic environment from LPAR manager environment
The following table shows the setting and checking items when LPAR
manager environment is transferred to Basic environment.
Table 2-9 Setting/checking item
Item
Setting/checking item
Before transfer
After transfer
Guest OS
IP address deletion (only for
windows)
IP address setting
(only for windows)
-
Driver installation
-
Teaming/Bonding
configuration
Server blade
EFI setting
1
-
Basic mode setting
1
-
Storage
-
WWPN/WWNN setting
Notes:
1
.
For details, see the Hitachi Compute Blade 500 series Server Blade Setup Guide.
IPv6 Setting for LP IP Addresses
You must set at least either an IPv4 address or an IPv6 address for LPAR
managers. Note that you can set both an IPv4 address and an IPv6 address
for LPAR managers.
•
When you desire to allow an LPAR manager to communicate with the
management module in IPv6, you must set an IPv6 address for the LPAR
manager and the management module in advance.
•
Set an LP IP address in an internet protocol in which you desire to allow
management server to communicate with LPAR managers. You can also
set two LP IP addresses in both IPv4 and IPv6 for an LPAR manager.
Firmware combinations
Server blade
Server blade
firmware
Management Module
firmware
LPAR manager
firmware
CB 520H B3
08-35 or later
A0260 or later
02-25 or later
CB 520H B4
10-03 or later
A0305 or later
02-50 or later
CB 520X B1
07-34 or later
A0260 or later
02-25 or later
CB 520X B2
09-17 or later
A0270 or later
02-27 or later
CB 520X B3
11-07 or later
A0320 or later
02-56 or later
2-18
System Operation
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
