English
20
APPLICATIONS
○
Cutting various lumber and pocket cutting
○
Cutting mild steel plate, aluminum plate, and copper plate
○
Cutting synthetic resins, such as phenol resin and vinyl chloride
○
Cutting thin and soft construction materials
○
Cutting stainless steel plate (with No. 97 blade)
PRIOR TO OPERATION
1. Power
source
Ensure that the power source to be utilized conforms to the power requirements speci
fi
ed
on the product nameplate.
2. Power
switch
To start the tool, squeeze the trigger and release it to stop. If you want to run the tool
continuously, press the lock button so that the trigger can be locked in ON position.
The trigger can be released easily from locked ON position, if you squeeze the trigger
slightly.
Ensure that the power switch is in the OFF position. If the plug is connected to a power
receptacle while the power switch is in the ON position, the power tool will start operating
immediately, which could cause a serious accident.
3. Extension
cord
When the work area is removed from the power source, use an extension cord of su
ffi
cient
thickness and rated capacity. The extension cord should be kept as short as practicable.
4. Dust produced in operation
The dust produced in normal operation may a
ff
ect the operator’s health. Either of following
way is recommended.
a) Wear a dust mask
b) Use external dust collection equipment
When using the external dust collection
equipment, connect the adapter with the hose
from external dust collection equipment.
5. Changing
blades
(1) Open the lever up to the stop. (
Fig. 1-
I
)
(2) Remove
fi
tted blade.
(3) Insert new blade up to the stop in the blade
holder. (
Fig. 1-
II
)
(4) Close the lever. (
Fig. 1-
III
)
CAUTION
○
Be sure to switch power OFF and disconnect the plug from the receptacle when
changing blades.
○
Do not open the lever when plunger is moving.
III
I
II
Lever
Blade
Blade holder
Fig. 1
000Book_CJ90VST_ChS.indb 20
000Book_CJ90VST_ChS.indb 20
2015/7/22 17:23:46
2015/7/22 17:23:46
