English
21
NOTE
○
Con
fi
rm the protrusions of blade inserted to
the blade holder surely. (
Fig. 2
)
○
Con
fi
rm the blade located between the
groove of roller. (
Fig. 3
)
6. Adjusting the blade operating speed
This Jig Saw is equipped with the electric
control circuit which enables stepless speed
control. To adjust the speed, turn the dial
shown in
Fig. 4
. When the dial is set to “1”, the
jig saw operates at the minimum speed
(850 /min). When the dial is set to “5”, the jig
saw operates at the maximum speed
(3000 /min). Adjust the speed according to the
material to be cut and working e
ffi
ciency.
CAUTION
At low speed (dial setting: 1 or 2) do not
cut a wood with a thickness of more than
10 mm or metal with a thickness of more
than 1 mm.
7. Adjusting the orbital operation
(1) This Jig Saw employs orbital operation which
moves the blade back and forth, as well as up
and down. Set the change knob shown in
Fig. 5
to “0” to eliminate the orbital operation (the blade
moves only up and down). The orbital operation
can be selected in 4 steps from “0” to “
III
”.
(2) For the hard material, such as a steel plate,
etc., decrease the orbital operation. For the soft
material, such as lumber, plastic, etc., increase
the orbital operation to increase work e
ffi
ciency.
To cut the material accurately, decrease the
orbital operation.
8. Cutting stainless steel plates
This Jig Saw can cut stainless steel plates by
using No. 97 blade. Carefully read “Concerning
cutting of stainless steel plates” for proper
operation.
9. Splinter
guard
Using the splinter guard when cutting wood
materials will reduce splintering of cut surfaces.
Insert the splinter guard in the space on the
base, and push it completely. (See
Fig. 6
)
Blade holder
Blade
Fig. 2
Roller
Roller
Blade
Blade
Fig. 3
Dial
Fig. 4
Change knob
Fig. 5
Splinter guard
Base
Fig. 6
000Book_CJ90VST_ChS.indb 21
000Book_CJ90VST_ChS.indb 21
2015/7/22 17:23:46
2015/7/22 17:23:46
