-28-
19. Disassembly and reassembly of the rear handle
[Tools required]
• Hex. bar wrench (5 mm)
• Phillips screwdriver
• Jig J-382 (Code No. 6600413) (Inner cap jig ass’y)
• Round bar about 2.5 mm in diameter
• Pliers
(1) Disassembly
• Loosen the seven Tapping Screws D6
[118]
by using a hex. bar wrench (5 mm), and remove the Front
Handle
[117]
, Lower Guard
[202]
, and Antivibration Spring
[201]
.
• Loosen the two Tapping Screws D4 x 16
[109]
by using a Phillips screwdriver, and remove the Rear
Foot
[200]
.
• Loosen one Tapping Screw D4 x 16
[109]
by using a Phillips screwdriver, and remove the Air Vent Cap
[110]
and Inner Cap (B)
[111]
.
• Loosen the Tapping Screw D4 x 25
[107]
by using a Phillips screwdriver, and remove the Trigger
Lockout
[131]
and Trigger Lockout Collar
[130]
. Push the Trigger Lockout
[131]
towards the Throttle
Lever
[134]
and pull it out to remove. For details, see the figure on the next page.
NOTE: The Rear Handle Set [114] cannot be disassembled into left and right parts as shown
below even by loosening the three Tapping Screws D4 x 16 [109] that secure the grip
portion, because the fuel tank is welded to the Rear Handle Set [114].
• Rear handle
[133]
[109]
[199]
[107]
[110]
[111]
[131]
[114]
[130]
[132]
[134]
[103]
[198]
[179]
[178]
[200]
[201]
[202]
[118]
[118]
[117]
[118]
[109]
[109]