-12-
●
1 After confirming that the power adaptor is connected to the main body, press the power
switch. (Fig.11)
“Low” on the level indicator lamp lights and “
COOL
” on the mode indicator lamp starts
flashing. If a lamp in another mode is flashing, press the mode switch button to
switch to “
COOL
.”
When the " HOT MASK " mode is finished, press the power switch and the "
COOL
"
mode will automatically be set.
3 Apply the cooling head gently to your skin and move it slowly just like patting your face.
(Fig.12)
The mode indicator lamp will change to lighting from flashing.
The cooling head does not vibrate.
The time for use is within one minute and 50 seconds.
Since you can apply the device to the same area of your skin for only one second,
repeatedly apply the head to your skin on and off towards the face.
4 After one minute and 50 seconds have elapsed, the device will be automatically shut off.
(Automatic shutoff function)
The finish sound (beep beep) will inform you.
When the “COOL” mode is finished, the main body and the cooling head become
slightly hot, however this is not unusual.
5 After use, make sure to pull out the power adaptor from the electric outlet and the main
body. (Fig.7)
If a toner/moisturizing product remaining on the skin attaches to the cooling head or
the main body, please wipe off with a tissue.
The power adaptor may become slightly hot during use, however this is not a device
failure.
2 Wait until the cooling head has cooled.
Preparation for cooling takes about 10 seconds. “
COOL
” on the mode indicator lamp
flashes during preparation.
When the device is ready for use, the ready sound will beep, and the mode indicator
lamp will be turned on.
●
●
●
●
●
●
●
●
●
The device does not vibrate in “
COOL
” mode.
CAUTION
Do not slide the cooling head over the skin.
Do not keep the cooling head in the same area of the skin, but move it around.
The cooling effect of the cooling head may be lessened.
CAUTION
●
●
CAUTION
If all of the mode indicator lamp and the level indicator lamp start flashing and the
abnormality detection sound beeps during use, this is a warning of device failure.
Pull out the power adaptor from the electric outlet, and contact the distributor for
repair.
About skin sensing function
This device is a product which operates through the human body. Applying the skin to
the back plate and the head will make an electrical circuit start to operate.
Unless you touch the back plate and apply the head to the skin, it will not start to operate.
●
