Command Control via the Network
Command Control via the Network
<RXFDQFRQ¿JXUHDQGFRQWUROWKHSURMHFWRUYLDWKHQHWZRUNXVLQJ56&
commands.
Communication Port
The following two ports are assigned for the command control.
7&3
7&3
Command Control Settings
&RQ¿JXUHWKHIROORZLQJLWHPVIURPDZHEEURZVHUZKHQFRPPDQGFRQWUROLVXVHG
Example: If the IP address of the projector is set to 192.168.1.10:
• Command control is not available via communication port (TCP
WKDWLVXVHGI27WUDQVPLVVLRQIXQFWLRQ
NOTE
1) Enter
[https://192.168.1.10]
into the address bar of the web browser.
2) Enter the Administrator ID and Password and click
[Logon]
.
&OLFN
[Port settings]
on the main menu.
4) Click the
[Enable]
check box to open
>1HWZRUN&RQWURO3RUW3RUW@
to use
7&3&OLFNWKH
[Enable]
check box for the
[Authentication]
setting when
authentication is required, otherwise clear the check box.
&OLFNWKH
[Enable]
check box to open
>1HWZRUN&RQWURO3RUW3RUW@
to
XVH7&3&OLFNWKH
[Enable]
check box for the
[Authentication]
setting
when authentication is required, otherwise clear the check box.
&OLFNWKH
[Apply]
button to save the settings.
(
9
)
