16
Power on/off
Turning on the power
1.
0DNHVXUHWKDWWKHSRZHUFRUGLV¿UPO\DQG
correctly connected to the projector and the outlet.
2.
Remove the lens cover, and set the power switch to
the ON position.
The power indicator will light up in steady orange (
63
).
Then wait several seconds because the buttons may not
function for these several seconds.
(1) When AUTO ON in OPTION menu is set to TURN ON
(
42
)
:
The lamp will only be automatically turned on when the
Power switch is turned on after the power was turned off by
Power switch last time. Afterwards the POWER indicator
will begin blinking in green. When the power is completely
on, the indicator will stop blinking and light in green.
(2) When AUTO ON in the OPTION menu is set to TURN OFF
(
42
)
:
Please see step 3.
3.
Press the STANDBY/ON button on the projector or the
remote control.
To display the picture, select an input signal according to the section
"Selecting an input signal" (
18
).
Turning off the power
1.
Press the STANDBY/ON button on the projector or the remote
control.
The message "Power off?" will appear on the screen for about 5
seconds.
2.
Press the STANDBY/ON button on the projector or the remote
control again while the message appears.
The projector lamp will go off, and the POWER indicator will begin
blinking in orange.
Then the POWER indicator will stop blinking and light in steady
orange when the lamp cooling is complete.
3.
Make sure that the power indicator lights in steady orange, and set the power
switch to the OFF position. The POWER indicator will go off. Attach the lens cover.
Do not turn the projector on for 10 minutes or more after turning it off. Turning the projector
on again too soon could shorten the lifetime of some consumable parts of the projector.
POWER
(Steady orange)
POWER
(Blinking in green)
POWER
(Steady green)
BLANK
LASER
ASPECT
ESC
MENU
RESET
POSITION
AUTO
MAGNIFY
MY BUTTON
VOLUME
ON
1
MUTE
OFF
2
FREEZE
KEYSTONE
SEARCH
PUSH
ENTER
PAGE UP
PAGE DOWN
STANDBY/ON
VIDEO
RGB
LASER
INDICATOR
STANDBY/ON
button
POWER
indicator
Power off?
WARNING
Ź
A strong light is emitted when the projector’s power is on. Do not look into
the lens of the projector or look inside of the projector through any of the projector’s openings.
Ź
Do not touch around the lamp cover and the exhaust vents during use or just
after use, since it is too hot.
NOTE
• Turn the power on/off in right order. Please power on the projector prior
to the connected devices. Power off the projector later than the connected devices.
• Use the shutdown switch
(
65
)
only when the projector is not turned off by normal procedure.
Power on/off
POWER
(Blinking in orange)
POWER
(Steady orange)
