23
English
Under the circumstances, pull a rubber cap
provided on the lever in the direction of an arrow
mark as shown in Fig. 17 and remove the rubber
cap from the lever. Then, clean up the inside of
the blade holder with air and the like and carry
out sufficient lubrication.
The rubber cap can be fitted on if it is pressed
firmly onto the lever. At this time, make certain
that there exists no clearance between the blade
holder and the rubber cap, and furthermore
ensure that the saw-blade-installed area can
function smoothly.
CAUTION:
Do not use any saw blade with a worn-out blade
hole. Otherwise, the saw blade can come off,
resulting in personal injury. (Fig. 18)
3. Adjusting the base
Loosen the set screw with an Allen wrench and move
the base forward, as shown in Fig. 19, Fig. 20.
Tighten the set screw slightly, ensure the base does
not move back and forth, and firmly tighten the set
screw. Ensure that the base does not contact the
blade.
4. Confirm that the battery is mounted correctly.
HOW TO USE THE CORDLESS RECIPROCATING SAW
CAUTION:
䡬
Avoid carrying it with your finger on the switch. A
sudden startup can result in an unexpected injury.
䡬
Be careful not to let sawdust, earth, moisture, etc.,
enter the inside of the machine through the plunger
section during operation. If sawdust and the like
accumulate in the plunger section, always clean it
before use.
䡬
Do not remove the front cover (refer to Fig. 9).
Be sure to hold the body from the top of the front
cover.
䡬
During use, press the base against the material
while cutting.
Fig. 18
Fig. 20
Fig. 21
Fig. 22
Set screw
12 mm
Allen
wrench
Fig. 19
Stroke
Base
Blade hole
Blade
Lever
Rubber cap
Fig. 17
Base
