– 6 –
S
S
S
T
T
V
T
U
U
V
Fig. 15 Care of motor protection filter
Abb. 15 Pflege des Motorenschutzfilters
HOW TO MAINTAIN CLEANING EFFICIENCY AND AVOID ACCIDENTS
• Be sure to replace the cloth filter after disposing of the dust.
If the cleaner is used with replacing its filter, dust will be sucked directly into the mechanical parts and may damage the
motor.
• Do not press or hit the clamp when carrying the cleaner. It may cause the dust receptacle to fall and hurt you.
• Do not block airflow.
Any blockages or obstructions to the suction inlet, rug and floor tool, extension pipe, hose, etc., or the exhaust air outlet
can cause loss of power and motor overheating.
• Do not pick up matches, fireplace ashes, or smoking material with the cleaner, as a possible hazard may result.
• Do not use the cleaner to pick up wet dirt, and avoid using the cleaner in a wet and moist place as moisture may damage
the motor and other mechanical parts.
• To clean the cleaner body and attachments, wipe them with a soapsuds-soaked cloth, and avoid using spirits.
• Avoid cleaning the switch area with a wet cloth and splashing water on it as moisture may cause a short circuit.
• The carbon brushes of the motor are of special composition.
When replacing the defaced carbon brushes, it is necessary to use only Hitachi special carbon brushes for the Hitachi
Vacuum Cleaner.
• Your vacuum cleaner is not a toy. Do not allow children to play with the cleaner. Do not leave the cleaner connected to an
electrical outlet and leave it unattended.
• Always disconnect cord from electrical outlet before servicing the cleaner.
CARE OF MOTOR PROTECTION FILTER (FIG. 15)
PFLEGE DES MOTORENSCHUTZFILTERS (ABB. 15)
Once or twice a year, or when it becomes visibly soiled, the motor protection filter
located under the upper case may require cleaning.
1. Remove the set of HEPA FILTER which is composed of HEPA COVER
T
and
HEPA FILTER
S
from MOTOR BASE
U
by pulling the lock as show in illustration.
2. Remove HEPA FILTER
S
from HEPA COVER
T
for cleaning.
3. Clean HEPA FILTER by shaking it to remove dust. (Do not wash.)
4. Assembly the set of HEPA FILTER. Attach HEPA FILTER
S
to HEPA COVER
T
first,
then fix with MOTOR BASE
U
by locking the latch of HEPA COVER
T
into the position of HEPA FILTER GUARD
V
.
Einmal oder zweimal im Jahr oder wenn er sichtlich verschmutzt ist, wird es wahrscheinlich
erforderlich sein, den Motorenschutzfilter, der sich unter dem oberen Gehäuse befindet, zu
reinigen.
1. Entfernen Sie den Satz des HEPA Filters, der aus HEPA Abdeckung
T
und
HEPA Filter
S
von Motorbasis
U
zusammengesetzt ist, durch Ziehen des
Schlosses als Vorstellung in Abbildung.
2. Entfernen Sie HEPA Filter
S
aus HEPA Abdeckung
T
um Sauber zu machen.
3. Reinigen Sie HEPA Filter dadurch, daß Sie ihn schütteln, um Staub zu entfernen.
(Bitte nicht waschen.)
4. Versammeln Sie der Satz des HEPA Filters. Schließen Sie ersten HEPA Filter
S
an zu Abdeckung
T
,
dann schließen Sie mit
Motorbasis
U
an Durch Schließen des Riegels von HEPA Bedeckung
T
in die Position der HEPA Filterwache
V
.
