-2-
Fig. 2 • Disassembly of inner cover (B) ass’y
Fig. 3 • Disassembly of second shaft (A) ass’y
2. Disassembly of the hammering mechanism
(1) Removal of the gear cover
Set the Change Lever
[11]{11}
to the "Ro Hammering" ( mark) position. Remove the four
Tapping Screws (W/Flange) D4 x 30 (Black)
[8]{8}
to remove the Gear Cover
[9]{9}
.
(2) Disassembly of inner cover (B) ass’y
Remove the two Seal Lock Hex. Socket Hd. Bolts M5 x 14
[34]{34}
from Inner Cover (B)
[35]{35}
.
Remove the assembly of the Piston
[31]{31}
and Second Shaft (A)
[43]{43}
from Inner Cover (A) Ass’y
[49]{49}
.
NOTE: The Seal Lock Hex. Socket Hd. Bolt M5 x 14 [34]{34} loses its bonding force if removed.
Use the new Seal Lock Hex. Socket Hd. Bolt M5 x 14 [34]{34} at reassembly.
(3) Disassembly of second shaft (A) ass’y
Engage the claw of the Clutch
[44]{44}
with the claw of the Reciprocating Bearing
[45]{45}
and place
the Clutch
[44]{44}
on a cradle as shown in Fig. 3. Push the rear end of Second Shaft (A)
[43]{43}
with
a hand press to push out the Bevel Gear
[48]{48}
from Second Shaft (A)
[43]{43}
. Then, remove Thrust
Washer (C)
[47]{47}
, Reciprocating Bearing
[45]{45}
, Needle Cage
[46]{46}
, and Clutch
[44]{44}
from
Second Shaft (A)
[43]{43}
.
[49]{49}
[31]{31}
[35]{35}
[43]{43}
[48]{48}
[47]{47}
[45]{45}
[44]{44}
[43]{43}
[46]{46}
Hand press
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com