--- 27 ---
Damper (A)
[31]
Stopper Ring
[34]
Damper Holder
[33]
5-mm diameter hole (2 pcs.)
O-ring (C)
[32]
Fig. 17
O-ring (B)
[30]
O-ring (1AP-20)
[28]
Second Hammer
[27]
Hammer Holder
[29]
Tap with a hammer.
Punch
(6) Removal of the cylinder and the second hammer
Remove the Stopper Ring
[34]
from the inside diameter portion of the Cylinder
[22]
. Then the Second
Hammer
[27]
, O-ring (1AP-20)
[28]
, Hammer Holder
[29]
, O-ring (B)
[30]
, Damper (A)
[31]
, O-ring (C)
[32]
and Damper Holder
[33]
can be removed from the Cylinder
[22]
. Remove the Stopper Ring
[34]
from the
groove of the inside diameter portion of the Cylinder
[22]
by tapping the Stopper Ring
[34]
through the 5-mm
diameter hole of the Cylinder
[22]
with a hammer and a punch as shown in Fig. 17. At reassembly, replace the
Stopper Ring
[34]
with new one as the removed Stopper Ring
[34]
is deformed. To prevent idle hammering,
also replace O-ring (C)
[32]
with new one at reassembly.
Summary of Contents for DH 24PD2
Page 26: ... 23 Fig 10 Dust collector B structure ...
Page 44: ......
