--- 24 ---
Front Cap
[1]
Stopper Ring
[2]
Ball Holder
[4]
Holder Plate
[5]
Holder Spring
[6]
Washer (B)
[7]
Grip
[3]
Fig. 17
Steel Ball D7.0
[17]
Grip
[3]
Fig. 16
(4) Disassembly of the tool retainer
Slide the Grip
[3]
fully in the arrow direction as shown in Fig. 16 and remove the Front Cap
[1]
. Pulling the
Grip
[3]
as shown in Fig. 17, remove the Stopper Ring
[2]
with a retaining ring puller. Then the Grip
[3]
, Ball
Holder
[4]
, Steel Ball D7.0
[17]
, Holder Plate
[5]
, Holder Spring
[6]
and Washer (B)
[7]
can be removed from
the Cylinder
[18]
.
(5) Disassembly of the cylinder and the second gear (slip mechanism section)
Remove the Gear Cover
[10]
from the Inner Cover Ass'y
[40]
and remove the entire tool retainer. Remove the
Retaining Ring for D20 Shaft
[8]
with a retaining ring puller. Stand the Gear Cover
[10]
in this state and pull
out the Cylinder
[18]
from the Gear Cover
[10]
with a hand press. Then Sleeve (A)
[15]
can be removed from
the Cylinder
[18]
. Remove the Retaining Ring 37 mm
[27]
from the Cylinder
[18]
with a retaining ring puller.
Then the Second Gear
[19]
, Spring (A)
[20]
and Washer (A)
[26]
can be removed from the Cylinder
[18]
.
Fig. 15
Change Lever
[25]
Pushing Button [
22]
Summary of Contents for DH 24PD3
Page 44: ......
